Hot led car modification light kit

led stroboscope car light 1.Easy to install and use 2.Brightness and fashion 3.Safety and maintainess free

    led car modification light kit

Characteristic :

1. Length : 2*90cm+2*120cm/set; 2*60cm+2*120cm/set; 2*60cm+2*90cm/set

2. Size: The width is 1.2cm

3. Voltage:DC12V(24V is available)

4. Color: RGB,blue,green,red,white,yellow are availiable

5. LEDs Specification: F5(5mm LEDs)

6. Material: black and flexible PVC

7. Light Source : Super bright plug LED can be controlled to change,different color manually by remote control(one controller with one remote may control one strip or two trips or four strips)

8. 24LEDs/30 CM

Setting up Instruction :

1. Lift the car with the elevator platform

2. Find the place you want to install,usually 4 LED strips is enough around the car. Clearing up where to install

3. Drill a hole at the chassis along with near to location of strips to be installed at 20-25cm intervals,if LED strips cann't be tied with cable ties at the location where to install strips.

4. Fix the strips on the chassis with cable ties after holes drilled

5. The power wire access can be 12V car power supply when installing. It can be controlled directly with our wireless remote controller to be light on and off.

6. Lighting test

7. Installation completed

Control modes :

A. button ON and OFF

B. mode button

    1. RGB full cycle 30 seconds

    2. RGB full cycle 15 seconds

    3. RGB full cycle 7 seconds

    4. Red ON

    5. Green ON

    6. Blue ON

    7. Red/Green ON

    8. Green/Blue ON

    9. Blue/Red ON

   10. Blue/Green ON

   11. Red/Green/Blue ON